QuizMe

1: Which of the following is false about using the Splice Key Editor?

We must always have "Hide the splice fibers" checked.

We must always have "Hide Fibers assigned to Saved Routes" checked.

We must use splice types "pending" for design and "fusion" for field spliced fibers.

We use the splice type "no splice" for buffer tubes that are whole in a mid-spanned cable.

2: If there is no slack or enclosure in a handhole there is no need to split the conduit

True

False

3: How should we save point to point routes in OSPInSight?

Starting at the HUB and ending at the Customer location

Starting at the Customer location and ending at the HUB

One fiber in one direction and the other fiber in the other direction

Starting at the southern location and ending at the northern location

Starting at the northern location and ending at the southern location

We should save each fiber twice going in both directions

4: How should we save in OSPInSight a ring that is going to 2 or more major POPs?

Starting at the northern POP

Starting at the southern POP

5: What do we do if the fibers that I need to splice are in use for something else?

We go running and crying to Mary or Drew, whoever is closer.

We delete the old route and use the fibers for the newer system.

We use the fibers for the newer system and change the old route to the next available fibers.

We use the fibers for the newer system and research the old route to figure out the real fibers that it was using.